Q&A
Control Units
CC-PJ-0707
Is it possible to perform ON/OFF switching by simultaneously triggering multiple CC-PJ-0707 units?
It is possible if inputs are connected in parallel.
This cannot be performed when connected in series.
QA No. 11-0138
It is a maximum of 50μs.
QA No. 11-0137
Is the included cable for the CC-PJ-0707 a robot cable?
It is not a robot cable.
It is the same as a CCS standard extension cable.
The minimum bending radius is R 30mm.
QA No. 11-0137
How is the CC-PJ-0707 Control Unit turned ON/OFF?
Please turn the primary power source power ON.
When turning it off, please turn the primary power source power OFF.
QA No. 11-0135
If an error occurs while using the CC-PJ-0707, will it recover by itself?
It cannot recover on its own.
After the cause of the error is rectified, please restart the primary power source.
QA No. 11-0134
What is the minimum time interval for the trigger input signal for the CC-PJ-0707?
It is a minimum of 75μs.
QA No. 11-0133
A waveform edge input method is used and it is a maximum of 50μs.
QA No. 11-0132
For the CC-PJ-0707, how many watts should be supplied for the external 24V?
7W or more should be supplied.
QA No. 11-0131
Although adjustment is possible, please ensure that excessive force is not applied.
QA No. 11-0130
Does the dimming for the CC-PJ-0707 exhibit linearity?
The dimming does exhibit linearity.
QA No. 11-0129
It is constantly performed using variable current control.
QA No. 11-0128
What precautions need to be observed when replacing a PJ Control Unit with the CC-PJ-0707?
Please note that there is no external dimming function (not possible to perform external control using the D-Sub 15 pin).
ON/OFF control is performed using a photo coupler specification and it is driven using DC 24V.
The input method used is DC 24V.
It is limited to a single channel.
QA No. 11-0127
Is it possible to perform external dimming for the CC-PJ-0707?
There is no external dimming control function.
QA11-0126